Home
  Uses
  Properties
  Insulation
  Tech Info
  Testimonials
  Contact Info
  FAQ's
  Order


 

rust preventative,high temperature metal insulating rustproofing coating


Insulating Metal Shield

Application Instructions

Surface Preparation: Surface should be clean and free of all contamination including dirt, oil and grease.
Remove oil or grease. Remove salt and dirt deposits using a fresh water rinse at low pressure.
Remove pack rust, loose coating and other foreign matter.

* Note - Encapsulating Lead Base Coatings.
OSHA respiratory requirements require half mask air purifying respirator with high efficiency filters (this is minimum requirement by OSHA when working with lead).

This product can be used as a single coat system or a two coat system. When using a two coat system a "wet on wet" application method is recommended.
This can be achieved by applying one coat of METAL SHIELD at 5-6 wet mils, let flash for two hours and apply another coat at 10 wet mils.

Equipment Airless spray - 30:1 Graco Bulldog with 3/8" I.D. high pressure line and a Graco silver gun with a .021-.024 spray tip.

Conventional spray - Use a DV-MBC gun or equivalent with a D fluid nozzle and a 64 air cap.
* Note - Brush and roller application can be used as well as other spray equipment.

Spread Rate for one coat system:
Recommended: Wet film thickness 11-13 mils.
Recommended: Dry film thickness 8-10 mils.
Sag Resistance: 60 mils.
Coverage: 150 square feet at 8 mils Dry Film Thickness.
Thinning: No thinning is recommended but use mineral spirits if necessary.
Mixing: Mix by hand.
Drying times
@ 75EF: Dust free.................60 minutes.
Firm........................48 hours.
Recoatability...........No maximum.
Clean Up: Clean equipment with mineral spirits.
Topcoats: Not normally required but may be top coated.



The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this website do not constitute a warranty, whether expressed, or implied as to the product performance. Hy-Tech Thermal Solutions, Inc can guarantee this product to conform to our standards of quality, and our liability, if any shall be limited to replacement of defective materials. Any or all technical information is subject to change without notice.
SEE THE PRODUCT MATERIAL SAFETY DATA SHEET (MSDS) AND LABEL WARNINGS FOR ADDITIONAL SAFETY INFORMATION.

 
Home | Uses | Properties | Insulation | Tech Info | Testimonials | Contact Info | FAQ's | Order